100
Setting the system
Select the baud rate to correspond with external remote control devices to control
this unit via the RS-232C interface.
Click the menu on the right side of “RS-232C BAUD RATE,” and select
the baud rate.
If you changed the setting, the unit needs to be rebooted.
When a message appears, click [Close], then click [SHUTDOWN] on the upper right
corner in the MAIN MENU screen to reboot.
Set the MIDI receive channel to receive data from MIDI devices when connected to
this unit.
Click the menu on the right side of “MIDI RECEIVE CHANNEL,” and select
the MIDI receive channel number.
You can connect external devices such as a CD player to play sound in addition to
the movie sound from the unit. In this case you need to adjust the volume balance
from both sources.
Click the menu on the right side of “AUDIO THRU VOLUME,” and adjust
the volume balance (0 – 100).
• At “0,” only the movie sound is output.
• At “50,” both movie sound and external sound source are output at the same level.
• At “100,” only the external sound source is output.
You can select the language of messages that appear on the display.
Click the menu on the right side of “MESSAGE LANGUAGE,” and select
the language.
• “ENGLISH” The messages are shown in English.
• “
” The messages are shown in Japanese.
You can select the mode that the unit is to start with upon power-up.
Click the menu on the right side of “START MODE” and select the mode
after startup.
• “PLAY MODE” The unit automatically starts up the Play Mode (p. 94) upon
power-up, and starts playback according to the setting.
• “MAIN MENU” The unit starts up with the MAIN MENU screen (p. 38).
Setting the RS-232C baud rate
Setting the MIDI receive channel
Adjusting the volume level balance between
external connected devices and this unit
Setting the message language to be displayed
Setting the mode after startup
000RG-100.book 100 ページ ２００４年８月６日 金曜日 午後５時３７分
