88
Using the Scheduler
You can program a schedule for control of this unit. For example, you can have it
shut down and enter standby mode, or get it to reboot.
1
In the time scale in the SCHEDULE EDITOR area, click on a time period at
which you wish to control the unit.
fig.scheduler16.eps
A
is marked on the spot where you clicked.
You can select the time spot by minutes.
2
At the selected time period, click [S.Down] to set the standby event, or
[Reboot] to set the reboot event.
fig.scheduler06.eps
If you have set the standby event, a red triangle appears under the line at the control
track. This triangle is shown at the time period you previously set in Step 1.
If you have set the reboot event, a blue triangle appears under the line at the control
track. This triangle is shown at the time period you previously set in Step 1.
3
Repeat Steps 1 – 2 as necessary to program other schedules.
Programming a schedule to control this unit
Time scale
Selected time period
[S.Down]
Control track
[Reboot]
000RG-100.book 88 ページ ２００４年８月６日 金曜日 午後５時３７分
