03
1. Align the screw holes of the Base (B) with the screw holes at the bottom
of the Column Floor Lamp (A) and fix them with Screws (C).
2. Connect the Adapter Connector (E) to the Adapter (F) and then spin the
lock of the Adapter.
3. Place the floor lamp where you need it and plug it in the power supply.
REMOTE CONTROL INSTRUCTIONS
1. ON/OFF Switch
2. Speed+/Speed-
：
Adjust the speed of the light change
3. Mode+/Mode-
：
Press +/- on Modes to get 358 lighting effects
4. Brightness-/Bri: Adjust the lamp’s brightness
5. Auto
：
Short press to play 358 lights effects automatically; long press
for 5 seconds to enter RGB colorful jump mode for lamp test;
6. Lock key: Remote control ID match, press 5 seconds for one-to-one
match (green light flash 3 times), and press 5 seconds again to unmatch
(white light flash three 3 times
）；
7. Set key: Adjust the RGB order, press 5 seconds and enter the setting
menu
，
then press RGB buttons to adjust the RGB order, press R until
lamp bar shows red, G until green, B until light bar shows blue, and exit
after mediation.
8. RGBW static monochrome mode.
Function
1
2
3
4
7
8
5
4
6
