ASSEMBLY AND OPERATING
INSTRUCTIONS
REF. 035555
ROLL MAT - 600 mm slate cutter
E
N
ASSEMBLY
DO NOT CARRY THE ROLL MAT BY ITS ERGONOMIC HANDLE. USE THE CARRYING STRAP OR
THE HANDLES ON EACH SIDE OF THE UNIT.
1 x1
x1
2
x1
3
Install the ergonomic handle
with the screw
and hex wrench
.
2
3
OPERATING
-
Straight position for ground work : Lock the foot in
the upper position on each side of the slate cutter.
- Tilted position for roof work : Lock the foot in the
lower position*.
*Can be easily attached to roof
battens thanks to its notches.
2/ Position the cutting stops using the clamping levers, depending on the cut to be made. Then place the slate on
the graduated cutting platform against the stops.
3/ Cut the slate by pulling on the handle to move the cutting
trolley.
4/ Empty the dust collector regularly by
detaching the strap to lift the hatch.
1/ Unscrew to release the cutting trolley.
2 different working positions
1
2/4
