Embedded Data Systems, LLC; 2019 Fortune Dr., Lawrenceburg, KY 40342; Phone/Fax 502-859-5490 10 / 37
EN-USERMAN OW-SERVER-ENET-2 V2.0 12.20.12
POST Client Configuration
The
POST Client Configuration
page of the Web tool allows you to configure the POST Client
and Proxy features of the OW-SERVER-ENET-2.
To configure POST Client
•
Enable the feature by click-
ing the check box
•
Select the URL of the
HTTP POST server. This
field requires a fully quali-
fied URL and may include
an alternate port number.
This example sets the port to 12391:
“http://www.embeddeddatasystems.com:12391/files/myfile.htm”
•
Select how often to send the “details.xml” file
•
Proxy server may be enabled by clicking the check box
•
Set the Proxy URL to the appropriate address, which is typically obtained from the net-
work administrator. For example, if the proxy server is at 192.168.1.230, port number
8080, then the Proxy URL field would be programmed to
http://192.168.1.230:8080
. The-
se proxy parameters only apply to the POST Client feature, they have no effect on any of
the other features.
1-Wire Configuration
The
1-Wire Configuration
feature of the Web-tool al-
lows you to configure the 1-
Wire interface on the OW-
SERVER-ENET-2.
At this time, the only configu-
ration setting allowed is to enable direct TCP communication with the 1-Wire bus. This allows
you to send commands directly to 1-Wire devices connected to the system. It is ideal for solu-
tions developers looking to integrate the OW-SERVER-ENET-2 with 1-Wire devices not current-
ly supported at a high level or for legacy applications.
For specific 1-Wire commands see Low
Level 1-Wire Communication Protocol in Appendix A.
To configure the port
•
Click the “Enable” check box `
•
Specify a port number through which communication will occur
•
When you are finished, click the “Save” Button to commit the settings to the device
