Changing Tip
1. IMPORTANT:
Make sure your tool is cool.
2.
Do not twist or wiggle Tip
3.
Loosen RCS71 Collar by turning it counter-clockwise.
3.
Remove old Soldering Tip.
4.
Insert new Tip.
5.
Tighten RCS71 Collar. (should be “finger” tight only)
WARNING:
Do not use the soldering tool if soldering tip is loose. This will cause the heater element to break.
XP375
LONER Extra Performance Spade Soldering Tip
.06” (1.5mm) .61” (15.5mm)
XP441
LONER Extra Performance Spade Soldering Tip
.20” (5.0mm) .59” (15.0mm)
LT371LF
LONER Spade Soldering Tip (Lead Free)
.03” (0.8mm) .55” (14.0mm)
LT375LF
LONER Spade Soldering Tip (Lead Free)
.06” (1.5mm) .48” (12.2mm)
LT375
LONER Spade Soldering Tip
.06” (1.5mm) .48” (12.2mm)
LT376
LONER Spade Soldering Tip
.12” (3.0mm) .48” (12.2mm)
LT394
LONER Spade Soldering Tip
.07” (1.8mm) .93” (23.6mm)
LT374
LONER Conical Soldering Tip
.03” (0.8mm) .48” (12.2mm)
LT382
LONER Conical Soldering Tip
.02” (0.5mm) .62” (15.8mm)
Soldering Tips
Iron Plated for long life-Nickel and Chrome Plated for optimum heat transfer
Contact Edsyn for more tip selections
Width A
Length B
SET-UP REQUIRED FOR SPADE, CONICAL, AND EXTRA PERFORMANCE TIPS
OPTIONAL:
Apply
AN112 Anti-Seize Compound or
AN122 High Heat Anti-Seize Syringe Dispenser
to Heater and area of Tip contact.
Extra Performance Tip
Spade or Conical Tip
RCS71
Retaining Collar
and Sleeve
SR574
High Performance
Hollow Heater
LTC71
Collar
More Tips are available at our website (www.edsyn.com) or in our General Line Catalog.
AN112
AN122
