3. Apply
AN112
(in tube) or
AN122
(in syringe) Anti-Seize
Compound before assembling.
INSPECT DAILY
4. Install
RS383
.
WT619
Tip Wrench
1. Remove RS383. Use WT619.
2. Replace Tip and install new Tip.
1. When desoldering small
holes on at areas, tilt
Tool to allow adequate
air ow to lift solder into
chamber.
2. When using SMD Tips, heat
up the connections by posi-
tioning the Tool perpendicu-
larly. When solder melts tilt
the Tool and depress trigger.
(SMD Tips are recomended
for HT500 using external
vacuum).
DESOLDERING POINTERS
REPLACING DESOLDERING TIPS
install
remove
Multi-Layered
Board
Heavy Duty Desol-
dering Tip
3. Extra-heavy duty desoldering on a multi-layeredboard
is done by using a Heavy Duty Desoldering Tip and
a Hi-Heat Soldering Tip simultaneously. Although
pre-heating of the circuit board will speed up the
process, it is not always necessary
.
Page 6
All manuals and user guides at all-guides.com
all-guides.com
