A) Head Assembly- Includes the primary
filtering system and solder debri cham-
ber.
B) Hot Tip Desoldering Tip- Wide range of
desoldering Tips applicable.
C) Head Shaft- Allows 4-point rotation of
Head Assembly.
D) Trigger- Activates vacuum suction.
E) Vacuum Hose- Low Static silicone hose.
Connects to vacuum source.
F) Connector- To 24 V controlled output.
(for HT500)
(for HT500-2)
G) Cleaning Shaft- For cleaning
Desoldering Tip orifice: .05 (1.3 mm) and
.025 (0.6 mm)
HT500
®
Hot Tip Desoldering Tool
D
A
F
(for HT500-1)
E
B
C
ADJUSTMENTS
The HT500 Head assembly can be adjusted into varying positions to suit the operator.
While Tool is in the Pod, push
handle down and twist handle
until it locks into 1 of it's 4 positions.
Twisting counter-clockwise will
permit a 180
0
turn. Twisting clock-
wise will permit a 90
0
turn.
Note: Head Assembly does not make a full 360
0
turn
To tilt the Head assembly, loosen (2)
Adjustment Screws. Tilt the Head as-
sembly to desired position. Retighten
Screws.
adjustment
screws
POWER REQUIREMENTS:
•24V
•VACUUM SOURCE
SPECIFICATIONS
• 24V, 50/60 Hz, 70W
• Weight: 11 ozs. (312 g)
• Temperature range of 400
0
F to 800
0
F (205
0
C-425
0
C)
• Voltage leakage from tip to ground, less than 2 MV
• Tip to ground resistance, less than 2 ohms
• COMPLIES WITH MIL-S-45743E, DOD-STD-2000-1B, WS-6536E and
ESD SPEC, DOD-STD-1686, DOD-HDBK-263
• UL Listed
ESD Safe
