Installing the base using seat belts
Open the base stand by pressing the stand release button and mov-
ing the locking clip from position 2 to 1 as shown in Figure (2) on
page 8.
Thread the lap belt and shoulder belt of the 3-point seat belt through
the seat belt guides as shown in Figure (1).
Connect the seat belt buckle as shown in Figure (2).
Pull the lap belt very tight at the buckle ensuring the stabiliser guard
is positioned flat against the back seat.
IMPORTANT
- make sure the lap belt and shoulder belt are tightly
wrapped around the seat before use.
WARNING
- the belt should be flat against the frame of the base. If
the seat belt is crimped reinstall the base.
IMPORTANT
- for vehicles with leather seats we recommend the use
of a rubber mat to reduce movement of the base.
Press the stand release button and extend the
stand feet to
lightly touch
the floor of your
vehicle.
10
designed in NZ
1
2
Summary of Contents for PA0100
Page 14: ...edwardsandcobaby com ...
