© Edwards Limited 2014. All rights reserved.
Page 7
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
NRD317880 Issue A
After removing all packaging:
Attach inlet and exhaust fittings. Note that an extension piece will be needed if an Exhaust Mist Filter (EMF)
or an inlet accessory is to be fitted - refer to
Figure 5
.
Locate first panel on left hand side of pump - refer to
Figure 6
.
Adjust pump position to suit.
Position pump power cable through hole provided.
Switch the motor start switch to ON.
Fit second cover on right hand side of pump - refer to
Figure 7
.
Fit end cover - refer to
Figure 8
.