D397-21-880 Issue G
Page 32
© Edwards Limited 2009. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
4.13.1
Organising gauges on the view screen
The three gauge order and one gauge order functions are used to set up what gauges and in what order the gauges
are shown on the view screen. In the following example the user wants to set the order below:
z
Position 1: The gauge plugged into the ’gauge 1’ connection.
z
Position 2: A gauge is not plugged into the ’gauge 2’ connection, the user does not want Position 2 to be
shown on the screen. The No gauge selection has been made.
z
Position 3: The gauge plugged into the ’gauge 2’ connection.
Figure 25 - Gauge order set up
Note:
The user can set up different ordering, to show three gauges or one gauge.
Once the set up is complete and the user views the screen, the gauge set up at position one is shown first. The user
can scroll around to all the other gauges set up in the positions defined. In the example above only 2 positions can
be scrolled to as the user has chosen that position 2 will not be shown when you return to the main view screen.
4.14
Relay setpoint outputs
The relay setpoints option allows the setpoint outputs on the logic interface to be linked to a gauge pressure or pump
speed. They are set up in the same way as Linking Gauges, refer to
When a relay setpoint becomes active, the display section on the view screen will change to reverse video.
4.15
Service information
Service information contains the following information:
z
Software Issue - This is the issue of the currently installed software. This will change when new software is
downloaded to the TIC in the future.
z
Serial Number - The serial number of the TIC is used when contacting Edwards about the product.
z
Analogue O/P - The analogue output value (internal units) is used when contacting Edwards about the
product.
z
Reset TIC - Resets the TIC to it's factory default configuration and can be used to quickly undo all user
settings (links between gauges and pumps, relay setpoints, units, gauge gas types, etc.).
4.16
Electrical supply failure
If the electrical supply to the TIC fails, any gauges connected and the logic interface will stop operating until the
power is restored.
