Notes:
Avoid placing objects in front of the motion detector
Avoid installation near air conditioners/central heaters/high voltage systems
Avoid placing the motion detector head towards high movement areas
Clean the solar panel with a moist soft cloth at least once a year
Clean accumulated snow as soon as possible during the snowing season
Do not expose the light to fire/intense heat or immerse in water
Never look directly into the light or shine it into another person’s eyes
Contact Info: (877)579-3889, sales@eesgi.com, www.eleding.com
EE805W-SFLH / EE805W-
SFLH(RGB)- 042017-page 2
Solar-Powered Outdoor/Indoor Flood/Decoration Wall Pack Light
eLEDing
EE805W-SFLH / EE805W-SFLH(RGB)
Quick Set-up Reference
Light Body Installation
For ground application, secure the ground stake on U-shape brackets, insert the ground stake in your desired location (Fig 1).
For wall-mounted application, drill the holes on desired locations, secure the bracket with provided screws (Fig 2).
For wood surfaces: drill the holes on pre-marked locations and install the mounting bracket.
For surfaces of concrete, brick or stucco: use a masonry bit (with appropriate size & length) to drill clearance holes.
Solar Panel Installation
An ideal installation area should be a flat and stable mounting surface that can ensure the maximum exposure to direct sunlight. An
average of 4-hour direct sunlight per day is necessary for dusk-to-dawn performance (Fig 3). The light will automatically turn off
when it detects low voltage from the battery caused by poor weather or bad location, this might happens after 3-4 cloudy days. For
northern hemisphere installation, a southern-facing solar panel is recommended and visa-versa for southern hemisphere
installation. East/west-facing installations with good sunlight exposure also works.
True Dusk to Dawn Illuminating Profile:
During daylight hours, the sun will charge the batteries through solar panel. During nighttime the light will automatically turn on in
darkness when the built-in photocell senses the ambient light level is lower than 10 LUX/ completely dark
.
When dawn comes, the
light extinguishes when ambient light level start to increase (This light is not featured with any motion sensing technology. For solar-
powered SMART lights with motion sensing features, please refer to other eLEDing & eSenlite products: www.eLEDing.com).
Functionality Test & Activation
Connect the solar panel with the light. If testing is lunched during daytime, make sure the solar panel is fully covered by a piece of
cardboard. Momentary press the red-color ON/OFF button to activate the light (Fig 4). If the light doesn’t turn on, recharge the
battery for 1-2 days. To shut down the light, long hold press the button for 1-2 seconds, then disconnect the solar panel from the
light after fully charged for storage
.
Setup Lighting Profile
EE805W-SFLH has two brightness mode: half and full (max) brigthess level. To continue pressing the ON/OFF button to select.
EE805W-SFLH(RGB) has 6 RGB color combination and 4 dynamic modes. To continue pressing the ON/OFF button to select.
Color changing sequences: RGB→R→RG→G→GB→B→RB→FLASH→STROBE→FADE→SMOOTH
Fig 1
Fig 2
Fig 4
Fig 2
