GENERAL INFORMATION
The Eemax Mini Tank water heaters can be used in most under the coun
-
ter, point of use applications. Models EMT2.5 and EMT4 are designed
to supply hot water for all hand wash and kitchen sinks in a residential,
commercial or industrial environment.
The EMT2.5 and EMT4 can replace traditional central hot water heaters
thereby conserving water and reducing energy waste.
The Eemax Mini tank water heaters are lightweight and compact and
manufactured for easy installation. The EMT2.5 and EMT4 are designed
to be mounted on the wall.
EMT2.5 and EMT4 are designed to operate at 150 psi maximum water
pressure. Install a pressure reducing valve if your water pressure is
greater than 150 psi.
CAUTION!:
The manufacturer cannot be responsible for the damage
caused by improper installation or by failure to follow instructions in this
manual. Comply with the Installation Instructions before connecting to
electrical outlet.
CAUTION!:
The thermostat has been pre-set at the factory between
41C (105F) and 45C (113F).
CAUTION!:
Hydrogen gas can be produced in a hot water system
served by this heater that has not been used for a long period of time
(generally 2 weeks or more). Hydrogen gas is extremely flammable. To
reduce the risk of injury under these conditions, it is recommended that
the hot water faucet be opened for several minutes at the nearest and
most distant sink being served by this water heater before using any
electrical appliance connected to the hot water system i.e. Dishwasher.
If hydrogen gas is present, there will probably be an unusual sound such
as air escaping through the faucet as the water begins to flow. There
should be no smoking or open flame near the faucet at this time.
WARNING:
Installer should review the contents of this manual with the
owner upon completion of the installation, and the manual should remain
with the owner and placed in a location close to the water heater.
Page 5
Eemax mini tank manual.indd 6
5/30/2008 10:44:50 AM
