BoxPC-NUCV|NUCR
Device Reference Manual – P – Revision 3
E.E.P.D. GmbH | Gewerbering 3 | 85258 Weichs
Copyright © 2019|2020 by E.E.P.D. GmbH. All right reserved. |
Rev.3.0
12
DIN Rail Mounting (optional)
The BoxPC is also designed for DIN rail mounting. There are drilled holes
for mounting the optional DIN rail holder in various positions (Fig.9).
Symbolic view for both sides.
Fig. 9: DIN rail holder positions
Please follow the instructions below:
•
Mount the top-hat rail holder with two screws M3x6mm at the
intended fastening points (see Fig.9+10). The top-hat rail holder is
suitable for “TS35” DIN rails.
•
Place the system on the DIN rail. Swivel it inwards until it snaps
securely into place.
•
To detach the system, push it from bottom to top. Swivel it outwards
and remove it.
Fig. 10: DIN rail holder mounting
