Original operating manual
Pneumatic circular saws
OM No.: 001 580 654
15 of 19
Version
26.06.2018
7.2 Daily maintenance
7.2.1
Tools and accessories
Grease gun
Suitable for contact with food
7.2.2
Lubrication
Each time the saw blade is cleaned, apply
a little acid-free, EFA special oil.
Lubricants
The lubricating grease and oil are subject to
the regulations required in the food industry.
Use only lubricants that comply with German
food regulations and FDA guidelines.
This relates to unintentional contact with the
processed product (food) that cannot be ruled
out with certainty. Therefore, use only food
grade lubricants.
You can buy suitable lubricating grease and oil
for your machine from the sales department of
Schmid & Wezel.
7.2.3
Saw blade
Inspect the saw blade at regular intervals.
If the self-locking effect of the hex. nut is no
longer assured, it must be replaced without
delay.
7.3 Advanced Maintenance
After approx. 50 operating hours, extended
maintenance is required.
7.3.1
Maintenance of the saw
Disconnect the saw from the compressed
air supply
To maintain the lubrication of ball bearings
and gearbox, grease the machine at the
grease nipples with 1 - 2 strokes out of the
grease gun (see Abb 19 and Abb 20).
Grease nipples (SK 18-8D)
Grease nipples (EFA 17 / EFA 19)
In case of decreasing performance or after
approx. 400 operating hours, the rotor
slides of the pneumatics motor must be
checked for wear and replaced if
necessary (we recommend sending the
pneumatic circular saw in this case to our
service department).
A dirty silencer (1) must be cleaned or
replaced.
1
