Original operating manual
Pneumatic circular saws
OM No.: 001 580 654
9 of 19
Version
26.06.2018
or the hook of the air circular saw. Be careful!
CAUTION
Risk of injury when adjusting
the
spring
balancer
with
pneumatic
circular
saw
attached!
Remove the pneumatic circular saw
before
adjusting
the
spring
balancer!
5. Handling
5.1 Switch operation
ATTENTION
Read the operating manual and
connect the pneumatic circular saw
correctly before turning on!
CAUTION
Machine damage and danger to
third parties due to improper
use!
Use the machine correctly.
WARNING
Cutting hazard: Limbs may be
severed!
Never reach into the area of the
saw blade.
Wear eye protection or safety
goggles during work!
The pneumatic circular saw is equipped with a
valve lever (1) for connecting the compressed
air flow.
Operating the switch lever (here SK 18-8D)
Operating the switch lever (EFA 17 / 19)
5.1.1
Turning on
1. Make sure that the manual pneumatic
circular saw is connected to the local
compressed air supply (supply pressure: 7
bar).
2. Carry out a function test before starting
work.
3. Hold the unit firmly by the handle (1).
4. To turn on, actuate the switch lever with
your index and middle fingers.
ATTENTION
Improper handling will lead to
increased wear!
Hearing impairment!
Ear protection is recommended
when used in continuous operation!
1
1
