Original operating manual
Pneumatic circular saws
OM No.: 001 580 654
11 of 19
Version
26.06.2018
standstill within 2 seconds. Only then may
the handles be released
To aid safe handling (guidance), the rib saw
should be hung on a spring balancer.
6. Assembly
WARNING
Cutting hazard!
Disconnect the saw from the
compressed air supply before
assembly operations!
6.1 Saw blade replacement
ATTENTION
Use only original EFA spare
parts!
This is the only way to ensure that
the machine functions properly
The following tools and accessories are
needed for disassembly / assembly:
Single open-end wrench (accessory)
Retention pin
6.1.1
Removing the depth stop
EFA 17, SK16D, SK16-8D:
1. Loosen the screw (1) at the pivot point
2. Unscrew the wing nut (2) and remove the
depth stop (3) (if installed).
Removing the depth stop (SK 16-8D) (1)
6.1.2
Removing the saw blade
3. Turn the saw blade manually until hole (1)
is congruent with hole (2).
Saw blade replacement (SK 16-8D) (2)
EFA 19, SK 16-8D, SK 18-8D:
Saw blade replacement (SK 18-8D) (3)
Wear cut-resistant protective gloves
when working!
4. Lock the saw blade (3) with a retaining pin
(4) (or a comparable tool) and unscrew the
clamping nut (5) with a single open-end
wrench (6) (right-hand thread) (Abb 10 and
Abb 11).
ATTENTION
SK16-8DR
Left-hand thread!
2
1
1
2
3
2
1
