Original operating manual
Pneumatic circular saws
OM No.: 001 580 654
7 of 19
Version
26.06.2018
3.2 Conduct at the workplace
Keep your workplace tidy and in good
working condition. A cluttered or messy
workplace can lead to accidents.
Take into account environmental
influences. Ensure good lighting (min. 500
lux).
Keep other persons away from your
workplace. Remain focused and act with
caution during your work.
Do not use the pneumatic circular saw
when you are tired and/or unfocused.
Avoid wearing loose clothing and jewelry
that can be caught by moving parts. Wear
sturdy shoes during your work. Always
wear a hairnet!
Ensure that your workplace has a correct,
ergonomic set-up. Ensure safe footing and
keep your balance at all times.
Store the pneumatic circular saw in a safe
place. Store unused equipment in a dry
place.
Service your tools with care. Only use
sharp and undamaged saw blades to
ensure safe work.
Use only original EFA accessories. Use of
other accessories will void the warranty.
The use of other tool inserts or
accessories presents a risk of injury to you
and other persons.
Lay down the unused pneumatic circular
saw so that accidental contact with the
sharp saw blade is not possible
4. Connection and start-up
4.1 Place of work
The work space for the operator should be at
least
1.5
sqm.
No other place of work should extend into this
area as movements with the pneumatic circular
saw could result in the risk of injury.
The illumination at the place of work must be at
least 500 lux.
4.2 Installation
CAUTION
Danger due to automatic start!
Connect the pneumatic circular saw
to the power supply only when
switched off!
CAUTION
Tripping hazard!
Lay compressed air lines outside of
the working area.
CAUTION
Danger of malfunctions and
injuries!
Installation work may only be
carried out by authorized specialist
personnel.
4.2.1
Connecting the pneumatic circular
saw
The pneumatic circular saw is supplied ready
for operation.
ATTENTION
Device damage!
Operate the pneumatic circular saw
only with clean, anhydrous, oiled
air!
Attach the pneumatic circular saw (1) with
the threaded nipple of the compressed air
