Pneumatically operated breastbone saw EFA 57
Operating instructions
EN
Part no. 110 885 700 – Rev. 00 – 01.2020
16 of 34
4. Transport and storage
The machine has been tested and carefully checked in our factory before shipment.
The test ensures that the machine is working properly.
Despite all care taken, there is a possibility that the machine could be damaged during transport.
Therefore, check the machine for possible transport damage when unpacking it.
Unpacking the machine
The machine is ready for use immediately after unpacking.
Storage of the machine
For safe storage of the machine, it is essential to observe the following instructions:
– Only store the machine in dry rooms.
– Only store the machine in a dry condition.
– Protect the machine from corrosion.
5. Connection and start-up
The working area for the operator should be at least 1.5 square meters in size.
No other workplace should protrude into this area, otherwise there is a danger of injury due to the actions
carried out with the EFA pneumatically operated breastbone saw.
The lighting of the workplace must be at least 500 lux.
The EFA pneumatically operated breastbone saw is delivered from the factory ready for use.
Caution!
Danger from unintentional switch-on!
Connect the EFA pneumatically operated breastbone saw to the compressed air supply only
when switched off!
Caution!
Tripping hazard!
Lay compressed air lines outside the traffic area.
Caution!
Danger of malfunctions and injuries!
Installation work is only allowed to be carried out by authorised specialist personnel.
Remove all packaging materials and dispose of them in a professional and environmentally friendly
manner.
Check the machine for possible transport damage.
Information on disposal and recycling can be found in
chapter 9
.
