Web browser
Connect Efento Gateway to your computer and change computer’s IP address to an address from subnet
192.168.120.0/24 (e.g. 192.168.120.2, subnet mask 255.255.255.0) and set it on the network card, to which
Efento Gateway is connected. Open an Internet browser on your computer and go to address
192.168.120.89 (default Efento Gateway IP address). Log in to the configuration panel of Efento Gateway
(default password:
admin
).
Status
Status tab provides you with the information about the operations of your Efento Gateway. This information
may be useful when diagnosing a problem or reporting a bug to the Efento support team.
Status tab
● Name, model, firmware version, UI version, MAC address: data used to identify the device
along with its name, MAC address and software version.
● Local time: time set on the device
● Last connection to server: timestamp of the last communication with the server. If device has
not communicated with server yet, the value will be empty
● Uptime: time since the last reset of the device
● Sensors in range: number of sensors in the range of Efento Gateway. Maximum number of
sensors supported by one gateway is 128
● Network status: value indicates the status of the network communication. If the value is
“OK”, device is able to connect to the Internet