UPS: OFFICE-RM 600 / 1000
Operation and Service
OFFICE-RM Series
30
6.1
Operation and operation modes of the UPS
As a rule, the switching on or starting and switching off of the device is carried
out by the operating personnel.
The operator of the UPS-system must always adhere to the instructions in this
operating manual. Only the operator can perform the following actions and must
always exercise particular care:
–
Switching on and off the UPS;
–
Reading the display messages and interpreting the acoustic warning
signals;
–
Switching from standard mode to autonomous mode and vice versa.
In addition, data can be exchanged with the UPS via the communication inter-
face(s), but this data exchange is not imperative for general operation. There-
fore, particular care and diligence are also required here as the UPS can, for ex-
ample, by shut down by the software.
6.1.1
Switching on the UPS, Charging mode
If the UPS is connected to the mains, the de-
vice starts automatically and starts with the ini-
tialization. The display shown here appears
briefly.
The device then automatically and automati-
cally switches to charging mode and changes
to the adjacent display
There is no acoustic signal when the UPS
starts up
In any case, it is advantageous to keep the device in charge for a few hours to
fully charge the battery before the UPS is switched on and assumes its support
function.
