Stand 08/2005
Seite 7
techbes_dt_MI_MIRM_050824.doc
Änderungen und Irrtum vorbehalten
EFFEKTA
UPS-Series MI
technical description
4. Installation
4-1. Install the UPS in a protected area with adequate air flow and free of excessive dust. Do not operate the UPS
where the temperature and humidity are outside the specified limits.
4-2. Check if the voltage as shown on the model label (on the rear cover) corresponds to your local power supply. If it
does not, consult your dealer.
4-3. Initial battery charging
The UPS is shipped from the factory with its internal battery in a fully charged state. However, the battery may be
lose some power during shipping and storage. The battery should be recharged before conducting the following
test for proper operation and to assure that UPS will provide expected run time. The battery is automatically
charge by the UPS whenever it is plugged in (no need to start-up the UPS). You can be sure that the battery is
fully recharged if the UPS were left plugged over 8 hours.
4-4. Connecting equipment(s) to the UPS
To ensure that your computer equipment will be protected during a utility failure and that you receive expected
run time, it is important that you determine the total power loading of the equipment you wish to protect by the
UPS. The power requirements of your equipment should be less than or equal to the capacity of the UPS. Once
you have determined that your equipment and the UPS are compatible, put your equipment’s plug into the UPS’s
rear panel output sockets.
5.
Operation
5-1.
Turning on the UPS
- Press and hold the “TEST” button till the first beeps sound over, and then the UPS is ready
to work. Otherwise the UPS will not work as if misstouch the switch only for a very short time.
5-2.
Turning off the UPS
- Press and hold the “TEST” button till the alarm beeps, then all the LEDs go off and the
UPS has been turned off.
5-3.
Silent mode
- On “BATTERY” mode, press the “TEST” button to stop the alarm until the low battery state, the
alarm will be active again.
5-4.
Self test
- Press the “TEST” button on “LINE” mode could force the UPS to enter the self test sequence. It returns
to “LINE” mode after pass the test.
5-5.
Load level -
Normally, the “POWER FACTOR” of the UPS is designed at
about 60%. That is, (if we put a 300VA for example) the total loading can not
exceed 180W for PF=1 or 300VA for PF=0.6.
