19
19
OPERATING INSTRUCTIONS
TIME………………………………………………….……....................................….00:00~99:59 MIN
SPEED…………………………………………………............................ 0.0~99.99 MI/H
DI S TA N C E …… … … …… … … …… … … …… … … …… . … .. . . . . . . . . .. . . . . . . 0 . 0 ~ 9 9 9 . 9 MI
CALORIE………………………………………………………............ ..0.0~999.9 KCAL
ODOMETER………………………………………………………………………………….…0~9999 MI
P U L S E … … … … … … … … … … … … … … … … … … … . . . . . . . . . . . . . . . . . . . . 4 0 ~ 2 2 0 B P M
The display will turn on when you start walking on the treadmill or when you press a key.
After 4-5 minutes of inactivity, the display will shut off automatically.
When the treadmill is not moving, computer will display “STOP” on the side.
MODE:
Press this button to select and set to a function. Hold for 2 seconds to reset the monitor.
The data for all functions will be cleared.
SET:
Under “STOP” condition, press this button to set the value of TIME, DISTANCE, CALORIES
or PULSE. You can hold the button for seconds to increase the data.
RESET:
Press this button to reset each function: Time, Distance, Calorie, Pulse. Hold for 2
seconds to reset the monitor. The data for all functions will be cleared.
(When you replace the batteries, all the values will reset to ZERO automatically.)
HOW TO SELECT A FUNCTION:
Press MODE to SCAN. To set a function, press MODE key when the pointer is on the function you
want and the function starts blinking.
FUNCTIONS:
1. TIME: Press the MODE key until pointer is set to TIME. The total working time will be shown.
2. SPEED: Press the MODE key until pointer is set to SPEED. The current speed will be shown.
3. DISTANCE: Press the MODE key until pointer is set to DISTANCE. The distance of each
workout will be displayed.
4. CALORIE: Press the MODE key until pointer is set to CALORIE. The calories burned will be
displayed.
5.ODOMETER:Press the MODE key until pointer is set to ODOMETER. The displays
accumulative distance from combined exercise sessions.
6. PULSE: Press the MODE key until the pointer advance to PULSE function and hold the pulse
sensor for about 3 seconds to measure pulse.
COUNTDOWN FUNCTION
：
Under “STOP” condition, press “SET” button to set Time, Distance or
Calorie to countdown. Once the data goes to zero, the computer will beep. That means
countdown function ends, and the data starts counting from “1”. You can set the Countdown
function only when the treadmill is stopped.
SCAN:
Displays each function for 4 seconds in the following sequence:
TIME—SPEED—DISTANCE—CALORIE—ODOMETER—PULSE
NOTE:
If the LCD display is not functioning properly, change the batteries. When you change batteries,
change both of them. The monitor uses 1.5V “AA” batteries.
Version 1.1
