Quick Operation Manual for ER3-600 Industrial Robot (EC2-S electric cabinet)
13
Fig. 2-4 Handling the Control Cabinet
2.4 Installing the Robot
Danger
1. Set up a safety fence to prevent from accidents leading to physical injury or property
damage. The robot should be placed in a position from which the end tool or the sharp end
of a workpiece can never reach the safety fence even if the robot arm is extended to its
reach limit.
2. Neither the power should be switched on nor should any operation be performed until
the robot has been properly fixed. Otherwise, accidents such as flipping, physical injury or
property damage might occur.
3. The ceiling or wall should be strong enough to bear the weight of the robot if it is
intended to be installed to a ceiling or a wall and the relevant emergency countermeasures
should be well-planned. Otherwise, accidents such as flipping, physical injury or property
damage might occur.
2.4.1 Setting up a Safety Fence
The user of the robot should set up a safety fence according to the National Standards of the People’s
Republic of China on
Robots and robotic devices―Safety requirements for industrial robots
Summary of Contents for ER3-600
Page 2: ......
Page 4: ......
Page 54: ...EFORT Intelligent Equipment Co Ltd 48 Fig 4 10 Main Power Switch...
