M o n i t o r i n g J u n i p e r E X S w i t c h
18
15.
DATA OVER TCP
–
By default, in an IT environment, all data transmission occurs over
UDP. Some environments however, may be specifically configured to offload a fraction of
the data traffic – for instance, certain types of data traffic or traffic pertaining to specific
components – to other protocols like TCP, so as to prevent UDP overloads. In such
environments, you can instruct the eG agent to conduct the SNMP data traffic related to the
Juniper EX Switch over TCP (and not UDP). For this, set the
DATA OVER TCP
flag to
Yes
.
By default, this flag is set to
No
.
Outputs of the
test
One set of results for the Juniper EX Switch device that is to be monitored
Measurements
made by the
test
Measurement
Measurement
Unit
Interpretation
Mode:
Indicates the mode of this
routing engine.
The values reported by this measure and
their numeric equivalents are available in the
table below:
Measure Value Numeric Value
Unknown
1
Master
2
Backup
3
Disabled
4
Note:
This measure reports the
Measure Value
s
listed in the table above to indicate the mode
of this routing engine. However, in the graph
of this measure, the mode of the routing
engine is indicated using only the
Numeric
Value
s listed in the above table.