5
4
4a.
Allow the lower part of the chassis to fully
open and lock into position with an audible click.
Push down on the basket frame gently to assist
with this process if necessary.
4b.
Release the handle by pushing the catch
situated at the side of the chassis above the rear
left wheel, squeezing the handle towards the
chassis if necessary. Lift the handle until it locks
into position with a click.
4c.
Rotate the seat upwards by lifting the back of
the seat until it is approximately vertical.
CAUTION: Do not try to move the seat unit until
the handle has been lifted into position. You may
damage the seat unit if you lift the seat before
placing the handlebar in the erect position.
Section 1 – The Chassis.
1. Front Wheels.
The front wheels are permanently fitted and
cannot be removed.
2. Locking & unlocking the front swivel wheels.
Rotate the barrel shaped collar at the top of the
front wheel unit left or right to lock or unlock the
swivel wheels. When locked the front wheels will
not be able to swivel and this may help when
travelling over uneven surfaces (e.g.
cobblestones).
3. Fitting/Removing the rear wheels.
Press and hold the button in the centre of the rear
wheel and push the wheel into the rear wheel
housing; release the button and the wheel should
lock in position.
IMPORTANT: Check each rear wheel is secure by
pulling outwards.
To remove; press and hold the button in the centre
of the rear wheel and pull the wheel away from the
wheel housing.
4. Opening the chassis.
With the stroller standing upright unlatch the
locking clip situated above the footrest by
reaching over the stroller and pushing down on
the footplate and pulling up the locking clip.
2
1
3
4
4a
4c
4b
PUSH
DOWN
PUSH
DOWN
ROTATE
& LIFT
PRESS
& HOLD
Quail Instruction Manual Dec 2017 v1_Layout 1 22/12/2017 12:12 Page 4
