57
1
2
Operator’s Manual City Ranger 2260
Operator’s Manual City Ranger 2260
Air filter housing Vacuum valve
Windscreen washer liquid cap
Service and maintenance
3.7 Cooler - continued
Preventing overheating
If the warning light is ON, all attachments must be
switched off and the engine must be run at half-
throttle. The air-intake grill in the rear screen must
be cleaned and the source of overheating located.
Engine temperature must fall to the normal level
within 30 seconds. The engine has a self protecting
system if the engine overheats, the engine de-rates
If you are in doubt about the cause, contact your
dealer.
Cleaning the water cooler
Described in section 3.1.
3.8 Air filter
Cleaning the air filter
1. When the City Ranger 2260 is operating in dirty
and dusty conditions, open the vacuum valve every
day to get rid of larger dirt and dust particles.
2. Open the air filter housing.
3. Remove the filter element.
4. Wipe the air filter housing with a clean cloth.
5. Carefully clean with compressed air from the
inside.
6. Put the air filter element back and close the filter
housing. (Picture 1)
3.9 Windscreen washer liquid
During winter, check that the windscreen washer
liquid
has frost protection properties.
1. The windscreen washer tank is in the cab, behind
the driver´s seat.
2. Pull the driver´s seat forward to access the
windscreen washer tank.
3. To add windscreen liquid, unscrew the cap, add
windscreen liquid and screw the filling cap on
again. (Picture 2)
Summary of Contents for City Ranger 2260
