67
1
Operator’s Manual City Ranger 3070
Operator’s Manual City Ranger 3070
3.10 Changing a wheel
Attention
Operate on level and stable ground.
The engine must be stopped and the
parking brake activated.
To carry out this operation, you require a jack able
to support two tones and a spare wheel with a
new tyre.
1. Chock the wheel opposite to the wheel to be
lifted.
2. Place the jack under the axle closest to the
wheel to be changed, in contact with the axle
body (point opposite to the arrow). (Picture 1)
3. Once the jack is well positioned, loosen the
wheel bolts.
4. Raise the jack until the wheel is a few
centimetres above the ground. Watch out the
vehicle stability when raising.
5. Unscrew and change the wheel. Screw the
bolts but do not tighten.
6. Lower the jack and then tighten the wheel bolts
to torque 120 Nm.
Attention
After 20 hours of use, tighten the
wheel bolts again to 120 Nm. Wheel
bolts should not be lubricated.
Attention
Only use tyre dimension and tyre
pressure as specified in section 1.4
page 12.
Attention
Changing tyres on rims may only be
carried out at an authorized workshop.
Lifting point
Service and maintenance
Summary of Contents for City Ranger 3070
