www.egiaudio.com
40250, 40260
control units
36
RADIO STATION TUNING AND MEMORIZATION
To select a radio station in the local tuner or the central unit, please do as
follows:
1.
Press repeatedly the
MENU
key
until
AUDIO
appears on the display.
2.
Then, press (
OK/+
) to visualize the selected program. (If you are tuning
a local program,
L
will appear).
3.
Press the
MENU
key
again and
MEM
followed by the memory
position of the tuned station.
4.
If you press (
OFF/–
) or (
OK/+/ON
) then, you will see the memory position
and frequency for the stored radio stations.
4.
Press (
OK/+/ON
) for a few seconds and navigate using (
OK/+/ON
) and (
OFF/–
) until
RSET
appears
on the display.
5.
Keep (
OK/+/ON
) pressed for some time and after about 3 seconds,
RSET
will stop flashing and
ST01
appears on the control units display.
The installation has been reset. Now, assign a new number to each zone following the procedure
“Zone
assignation”
.
NOTE:
You can exit to the main menu at any time pressing
EXIT MENU
key
several times.
audio functions
From your
EGi
ref.
40250
and
40260
control unit, you will have control over the audio programs in your
installation.
VOLUME CONTROL
To modify the volume in the room where the control unit is installed, press (
OK/+/ON
) to increase or (
OFF/–
)
to decrease the volume. Keeping (
OFF/-
) pressed, switches off the control unit.
PROGRAM CHANGE
Depending on the central unit and the control unit of your system, up to 3 programs
can be chosen. (3 general and a local one, depending on the control unit).
To change between available programs, press the
MENU
key
until
AUD
appears on the display. Then, using (
OK/+
) check the available programs.
NOTE:
To exit to the main menu at any time, just press
EXIT MENU
key
twice.
A U D I O
P RO G R L
VOLUME CONTROL
PROGRAM CHANGE
R E S E
T
ADJUSTM
– M I S C E L
S E T U P
1
st
1
st
2
nd
2
nd
1
st
2
nd
1
st
2
nd
1
st
Summary of Contents for DOMOS2
Page 1: ...english user s manual ...
