47
RESET SYSTEM ZONE ASSIGNMENT
If you need to
SETUP
the installation, you must reset (from the control unit)
the installation.
Follow the instructions to do so.
1.
Press the
MENU
key
3 times,
AUDIO
>
INTERCOM
>
SURVEIL
>
until
MISCELL
is displayed.
2.
Press (
OK/+/ON
) for 2 seconds.
3.
Press the
MENU
key
several times until
SET
appears.
4.
Press (
OK/+/ON
) for a few seconds and navigate using (
OK/+/ON
) and
(
OFF/–
) until
RSET
appears on the display.
5.
Keep (
OK/+/ON
) pressed for some time and after about 3 seconds,
RESET
will stop flashing and
ST01
appears on the control units display. The
installation has been reset. Now, assign a new number to each zone
following the procedure
“Zone assignation”
.
NOTE:
You can exit to the main menu at any time pressing
EXIT MENU
key
several times.
audio functions
From your
EGi
ref.
40270
and
40280
control unit, you will have control over the audio programs in your
installation.
VOLUME CONTROL
To modify the volume in the room where the control unit is installed, press (
OK/+/ON
) to increase or (
OFF/–
)
to decrease the volume. Keeping (
OFF/–
) pressed, switches off the control unit.
PROGRAM CHANGE
Depending on the central unit and the control unit of your system , up to 3 programs can be chosen (3 general
and a local one, depending on the control unit).
To change between available programs, press the
MENU
key
until
AUDIO
appears on the display. Then,
using (
OK/+/ON
) check the available programs.
NOTE
:
To exit to the main menu at any time, just press
EXIT MENU
key
twice.
r e s e t
–
–
–
–
S E T- U P
1
st
2
nd
1
st
1
st
2
nd
40270, 40280
control unit
contr
ol unit
A d j u st m
m i s c e l l
2
nd
1
st
2
nd
1
st
Summary of Contents for DOMOS2
Page 1: ...english user s manual ...
