DOC
：
EG-IM-GGHC20200313
Changzhou EGing Photovoltaic Technology Co., Ltd
Add
：
No.18, Jinwu Road, YaotangTown,Jintan District, Changzhou City, Jiangsu, China
Web
：
www.egingpv.com
：
eging@egingpv.com
TEL
：
+86-0519-82588999/82585885
Date:Mar. 2020 Page:
9 / 14
4.5.2
EG-***P60-HC/BF-DG
和
EG-***M60-HC/BF-DG
组件安装方式
Installation of
EG-***P60-HC/BF-DG and EG-***M60-HC/BF-DG
对于
EG-***P60-HC/BF-DG
和
EG-***M60-HC/BF-DG
系列组件，尺寸为
1692*994*30mm
。
For the EG-***P60-HC/BF-DG and EG-***M60-HC/BF-DG series of glass- glass module, the size is
1692*994*30mm.
4.5.2.1 四个压块安装方式
如图
6
所示，压块安装位置位于双面双玻半片组件长边，安装支架平行于组件长边，安装支架切勿遮挡电
池片，压块中心位置到组件短边距离为
A
，
A
必须在
346
±
25mm
之间，两个压块中心位置间距为
B
，
B
必须在
1000
±
25mm
范围内，图
7
为双面双玻半片组件边框型材图，压块与组件型材
A
面的重合长度为
S
（图
8
），
S
不能大于
9.5mm
，压块与安装支架之间使用螺栓连接（图
9
），组件边框接地孔安装如图
10
所示。
As shown in figure 4
，
The mounting position of the block is located on the long side of the modules
，
The mounting
bracket is parallel to the long side of the modules
，
Do not block the battery sheet when installing the bracket
，
The
distance from the center of the two side blocks to the short side of the modules must be between 346
±
25mm
，
The
distance between the center of the two blocks must be 1000
±
25mm
，
FIG. 7 shows the frame profile of the modules
，
The overlapping length between the block and profile A of the modules is S (figure 8)
，
S cannot be greater than 9.5mm
，
Bolted connection between block and mounting bracket (figure 9)
，
The modules grounding is shown in figure 10.
图
7
：双面双玻半片组件边框型材图
Figure 7: sectional view of the aluminum
图
6
：压块安装位置图图
8
：压块尺寸要求图
Figure 6: location diagram of the block installation Figure 8
：
size requirement of block
