Eglo SEACLIFF 20523401, Installation Manua

6

SEACLIFF 

Ceiling Fan

SELECTING A LOCATION:

1.

The ceiling fan must be installed in a location so that the blades are a
minimum 300mm spacing from the tip of the blade, to the nearest objects
or walls.

2.

The ceiling fan must be installed in a location so that the blades are a
minimum 2.1m above the floor.

3.

The fixing point for your ceiling fan must be of sound construction,
undamaged, and capable of supporting a load of 35Kg, or 4 times the
weight of the fan plus the method of attachment, whichever is greater. If
the location does not have a solid mounting point, you will need to install a
timber support between two ceiling joists. Refer to Fig. 2

4.

Many EGLO fans are designed for indoor use, though they can also be
installed in appropriately covered outdoor locations where the fan is fully undercover with a minimum of 2 walls. This fan is not
waterproof. When installed in outdoor areas, the ceiling fan must be installed in a location protected from water, wind, dust, and
salt. Exposure to these elements will void the warranty. In some more tropical areas of Australia, it is suggested you increase the
distance from the fan to the edge of the roof.

INSTALLING THE MOUNTING BRACKET:

1.

Install the mounting bracket to the ceiling joist or timber support with the long installation screws
provided. Pass the screws through the slotted holes in the mounting bracket and secure to the
ceiling. Refer Fig. 3

2.

Ensure that at least 30mm of the screw is threaded into the ceiling joist or timber support.

Note:

 The fixing screws included are designed for use with timber ceiling joists, for all other materials,     

the appropriate fixing screws will need to be purchased.

ASSEMBLING AND INSTALLING THE FAN:

IMPORTANT: 

Check that the power is disconnected and/or the mains switched off at the  

circuit box to ensure all pole isolation of the power supply.

1.

Carefully lift the fan assembly up to the hook of the mounting bracket. Wire the ceiling in accordance
to; “Wiring Connections” on page 7. Refer Fig. 4

2.

Install the safety wire to the ceiling, the safety wire must be adjusted as short as possible and secure
until snug. Refer Fig. 4

3.

Install the fan assembly to the mounting bracket by aligning the holes in the fan assembly with the
holes in the mounting bracket, and fixing with 4 screws and washers. Refer Fig. 5

4.

Wire in accordance to Wiring Connections on page 7.

5.

Carefully lift the housing up to the mounting bracket and secure it with 4 sets of screws and washers.
Refer Fig. 6

6.

Working one blade at a time, place the blade under the blade attaching ring beneath the housing.
Insert the two blade screws and washers, and tighten both blade screws loosely, and when all blades
are installed tighten all screws firmly. Refer Fig. 7

7.

For non-light models; Attach the bottom cover (down cover) by aligning up against the axis of motor
and turning Clockwise to fasten. Refer Fig. 8

8.

For models with LED light; Remove the 3 screws on the fitter plate below the blades.
Connect the plug from the fan to the plug connector on the LED boards. Refer Fig. 11
Align the slotted holes on the light plate with the fitter plate, and attach with the 3 screws removed
earlier. Refer Fig. 9
Install the light shade by aligning with the light plate, and gently press shade onto plate. Refer Fig. 10

Fixing point MUST

be able to support 

a 35 kg load.

NOTE: Image is for representation only,

and does not represent the actual bracket.

Fig 2

Fig.

 2

Fig 3

Fig.

 3

Fig.

 4

Fig.

 7

Fig.

 6

Fig.

 8

Fig.

 5