6
Step 4.
(Figure 11) If your outlet box has a ground
wire (green or bare copper) connect it to the fan
ground wires; otherwise connect the hanging bracket
ground wire to the mounting bracket. Secure the wire
connection with a plastic nut provided. After
connecting the wires, spread them apart so that the
green and white wires are on one side of the outlet
box and black and blue wires are on the other side.
Carefully tuck the wire connections up into the outlet
box.
NOTE:
Fan must be installed at a maximum distance
of 30 feet from the transmitting unit for proper signal
transmission between the transmitting unit and the
fan's receiving unit.
Step 1.
Tuck connections neatly into ceiling outlet
box.
Step 2.
Slide the canopy up to hanger bracket and
place the key hole on the canopy over the screw on
the hanger bracket, turn canopy until it locks in place
at the narrow section of the key holes.
Step 3.
Align the circular hole on canopy with the
remaining hole on the hanger bracket, secure by
tightening the two set screws.
NOTE:
Adjust the canopy screws as necessary until
the canopy and canopy cover are snug. (Fig. 12)
WARNING:
Make sure tab at bottom of hanger
bracket is properly seated in groove of hanger ball
before attaching canopy to bracket. Failure to
properly seat tab in groove could cause damage to
electrical wiring.
Fig. 12
Hanger
bracket
FINISHING THE INSTALLATION
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Fig. 11
White (neutral)
White (neutral)
Green or bare
copper (ground)
White ("AC IN N")
White ("to motor N")
Ground
(green)
(Connect to
ground wire on
hanger bracket
if no house
ground wire
exists.)
Outlet box
Black (hot)
Black ("AC IN L")
Black ("to motor L")
Receiver
Black (motor)
Blue (for light)
Blue (for light)
