4.3 Email Templates
egnite Querx sends email notifications when alerts
occur and when the values return to their normal state.
Open the page
Interfaces / Email
in the configuration
area to configure the format of these email
notifications.
1.
Enter a
Subject
for the email notifications in the
section
Alert notifications
.
2.
Enter the contents of the email in the input field
Message
.
You can use the following placeholders in the
notifications’ subject and main body. The placeholders
are automatically replaced by the current values when
notifications are sent.
$N
Name of the system that triggered the alert
$S
Name of the sensor that triggered the alert
$U
The measured value’s physical unit
$I
The device’s IP-address
$L
The device’s location
$V
The value measured by the sensor that triggered
the alert
$E
Description of the event
$D
The date on which the event occurred
$T
The time at which the event occurred
$C
The contact person for the device
Enter the event descriptions as described in the
following section before saving.
44