Smart. Solar
. Box
Smart. Solar
. Box
Installation and user handbook - rev. 1.1 of 13|09|2018
28
When unused for short periods of time
In the event of the
EGO
integrated solar collector with accumulation tank not being used for
a period of up to 30 days it is possible to leave the plant filled with water and the solar col-
lector uncovered.
Nevertheless, before reusing the hot water it is a good idea to completely empty the tank and
then refill it again.
In case of not using the collector for longer periods (e.g. when putting out of service in win-
ter), completely empty the accumulation tank (see below) and cover with the sheet supplied.
Emptying
Whenever it is necessary to empty the EGO system, for example in case of maintenance or pro-
tection against low temperatures, carry out the following steps:
Before the emptying operation, the solar collector must be covered with the sheet supplied
or with an appropriate blacking-out system, in order to avoid causing damage to the system
by any heat that could form inside due to the absence of water.
a) Turn on a tap of one of the users and allow a sufficient amount of water to flow in for
lowering the temperature and rinsing out the system.
b) Close the shut-off valve at the inlet.
c) Disconnect the return line from the by-pass valve.
d) Open the drainage tap and convey the outlet water down the drain.
Electrical integration kit
Types of elecric resistor
Even though the system was designed to operate in temperate zones with good radiation, it
has a greater range of uses if combined with ELECTRIC RESISTORS, available as optional ac-
cessories to be requested.
THERE ARE 3 TYPES OF RESISTOR AVAILABLE:
ANTIFREEZE ELECTRIC RESISTOR
Power:
300 W – 230V/50Hz
Threaded connection:
M 1”1/4
Thermostatic operation :
ON +5°C / OFF +8°C
Sensitivity:
± 5 °C
Article code:
4400234100
Identication
:
green circle
ELECTRIC RESISTOR FOR INTEGRATION
Power:
1.000 W – 230V/50Hz
Threaded connection :
M 1”1/4
Thermostatic operation :
ON +50°C / OFF +55°C
Sensitivity:
± 5 °C
Article code:
4400234101
Identification
:
red circle
ELECTRIC RESISTOR FOR INTEGRATION
Power:
2.000 W – 240V/50Hz
Threaded connection:
M 1”1/4
Thermostatic operation:
ON +50°C / OFF +55°C
Sensitivity:
± 5 °C
Article code:
4400234102
Identification
:
yellow circle
OPTIONAL
OPTIONAL
OPTIONAL
If any antifreeze or integration resistors have been installed, these must be deactivated.RR-
