LUBRICATION:
MAINTENANCE
TROUBLESHOOTING GUIDE
The treadmills have already been spread with "Silicone Oil" in advance before leaving the
manufacturing plant. Silicone oil is without volatility and has gradually permeated through
the running belt.
NOTE: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any
other oil ingredient; otherwise the treadmill will be damaged. Do not over-lubricate the
walking board. Excess lubricant should be wiped off with a clean towel.
Adjust the running belt
Carrying out a simple and regular maintenance in the machine will reduce the wear of the
parts, remove annoying noises, increase the life of the machine and enjoy more your
workouts.
An incorrect machine leveling on the contact points or weight and running styles differences
can produce the running belt to shift sideways.
Needed tool:
- Allen Wrench 5mm
CASE 1:
BELT OFFSET TO THE LEFT
Check the side to examine if the running belt is offset to the side.
Set the unit in motion at a speed of 3km/h, if the belt has moved to the left, turn screw(L)
on the left-hand side of the machine a 1/2 turn clockwise.
Look at the position of the belt. If after one or two minutes the belt is not totally centered,
please repeat the procedure.
Once the belt is adjusted, you can start the workout again.
If the belt has excessively moved to the right, turn screw(L) on the left-hand side of the
machine a 1/2 turn anticlockwise.
Look at the position of the belt. If after one or two minutes the belt is not totally centered,
please repeat the procedure.
E01
E02
E03
E04
E05
E06
Possible Causes
Problem
Console communication failures
Motor failure
Speed sensor failure
Motor Circuit disconnection
Over current protection
The supply voltage is too low
Note
Drives do not receive a digital signal
With inductive drive
23
24
※Tips: Usually it requires lubrication every 15 days, however if quite
frequent use, we suggest apply lubricant every 7 days. Pour 15ml
each time, that is, half of the bottle included in the package.
