6
RESET hole & Microphone
You can reset the system setup of your player by pressing the RESET hole.
It is used for recording the outside voice or FM radio while the player is playing record
function.
Micro SD/Tflash card slot
Support Micro SD/Tflash card.
Note: Please do not install or pull out the Micro SD/Tflash card while your player
is in power on state.
Earphones jacks
There is a earphones jack on the left side of the player.
Charging Li –polymer battery safely
1.
Connect the PC USB port and the player USB port with the provided USB cable.
2.
The power sign is shown dynamic when charging, once full charged, the power
sign will stop moving, power is full, please shut off the power. The charging time is
approximately 3 hours
.
3.
To stop recharging, disconnect the USB cable.
Notes
Before your first time use, please recharge your digital player.
Your computer must be turned on while connected to your player for charging.
Do not overcharge your player, or it may shorten the battery’s life.
CAUTION
1.
Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
2.
Make sure the output voltage of power supply is 4.8V ~ 5.5V, and the rated current
is more than 400mA.
Summary of Contents for MD398IFOD
