13
Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction completely and follow the
instructions contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the connection cable gets damaged or cut during the use,
do not touch it, but instantly pull the plug out of the socket.
Never use the tool with a damaged connection cable.
Do not use the tool near explosive materials (petrol, dilution).
Do not work with materials containing asbestos.
Modifications of the tool are prohibited.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
tool switch is off.
Always use the machine with a GFCI..
The machine should only work under supervision of somebody. Plug
and switch the machine off if it is not under supervision, e. g. in case of
putting up and stripping down the machine, in case of setting up and
striking, voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Do not use the machine if one part of the housing is damaged or in
case of damages on the switch, cable or plug.
Pay attention that the speed indicated on any disc or tool meets or is
higher than the max. speed indicated on the machine.
Grinding wheels have to be stored and used carefully and following the
instructions of the producer.
Check the accessories before use. Do not use any products which are
broken away, cracked or damaged in another way.
Before use, make sure that the tool is correctly fixed and fastened. Let
it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
In case of using grinding tools with internal thread, make sure that the
internal thread is long enough to receipt the whole spindle thread
length.
When using the machine no cooling water is allowed to get into the
motor and the electric mounting parts, no matter in which position you
work.
If water leaks from the overrun bore hole in the water supply, stop
working and have the tool repaired in an authorised service workshop.
