24
Auto-stop brushes
In order to protect the motor, this power tool is equipped with auto-stop
brushes. When the carbon brushes are worn out, the machine switches
itself off. In this case both brushes must be replaced at the same time with
original brushes by an electrical specialist.
Warranty
According to the general supply conditions for business dealings, suppliers
have to provide to companies a warranty period of 12 months for redhibitory
defects. (To be documented by invoice or delivery note). Damage due to
natural wear, overstressing or improper handling are excluded from this
warranty. Damages due to material defects or production faults shall be
eliminated free of charge by either repair or replacement.
Complaints will be accepted only if the tool was returned in non-dismantled
condition to the manufacturer or an authorized Eibenstock service centre.
EU - Declaration of Conformity
We declare under our sole responsibility that the product described under
“Technical Data” is in conformity with the following standards or
standardization documents:
EN 62841-1, EN 62841-2-1, EN 55014-1, EN 55014-2, EN 61000-3-2,
EN 61000-3-3
according to the provisions of the directives 2011/65/EU, 2014/30/EU,
2006/42/EG
Technical file (2006/42/EC) at:
Elektrowerkzeuge GmbH Eibenstock
Auersbergstraße 10
D – 08309 Eibenstock
Lothar Lässig Frank Markert
General Manager Head of Engineering
06.04.2022
In addition there is a service indicator on the operating
handle which indicates in advance that the machine is
about to shut down due to worn carbon brushes. After
the indicator lights up, you can use the tool for
approximately 1 day. Then the carbon brushes should
be replaced.
Summary of Contents for ESD 162
Page 2: ...1...
