18
Application for Indented Purpose
The diamond core drill
PLD 182
is indented only for professional use and
may be used only by instructed personnel.
It may be used either with or without a suitable diamond drill rig. With an
appropriate drill bit, the tool can be used for wet cutting of concrete, brick
and stone.
For wet drilling jobs with diameters above 70 mm and drilling in the 1
st
gear, it is a must to use a suitable drill rig.
Drilling in the 1
st
gear without drill rig is prohibited!
On careless use, counter torques may cause danger to the user!
Safety Instructions
Safe use of the tool is only possible if the user had
studied the instruction manual and safety instructions
completely and is strictly following the instructions
contained therein.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the mains cable gets damaged or cut during the use, do
not touch it, but instantly pull the plug out of the socket.
Never use the tool with damaged mains cable.
Prior to drilling in walls and ceilings, check them for
hidden cables, gas and water pipes and other media.
Check the working area, e.g. using a metal detector.
Prior to the start of your work, consult a statics specialist
to determine the exact drilling position.
If drilling through ceilings, secure the place below,
because the may fall downward.
The tool must neither be wet nor used in humid
environment.
Do not use the tool in an environment with danger of explosion.
Do not use the tool standing on a ladder.
Do not drill into asbestos-containing materials.
Do not carry the tool at its cable, and always check the tool, cable and
plug before use. Have damages only repaired by specialists. Insert the
plug into the socket only when the tool switch is off.
Modifications of the tool are prohibited.
Unplug the tool and make sure that the switch is off if the tool is not
under supervision, e.g. during preparation and take-down works, at
power failures, for insertion or mounting accessories.
Unplug the tool if it stops for any reason. So you avoid sudden starts in
unattended condition.
Don’t use the machine if a part of the housing is damaged or in case of
damages on the switch, the cable or plug.
