27
USER MANUAL
MAGIC 500 PLUS ULTRASOUND UNIT
T +49 7461 96 580 0 | F + 49 7461 96 580 90 | export@eickemeyer.com | www.eickemeyer.com
6. Press
key to quit the measurement status.
7. Press direction keys
to choose “Clear” and press
key to clear all marks and data.
8. Press
key to return the real-time status.
Circumference / Area Measurement with Point Method
1. In B, B / B mode, freeze the desired image, press direction keys
to move the cursor to “Measure” position of display area.
2. Press
key, the measurement methods are shown in the lower left of the screen, press direction keys
to choose
“4.Point”, press
key again, the cursor will show “+”.
3. Press direction keys to move the “+” mark to desired position, press
key to mark the fi rst point, continue to press
direction keys, move the “+” mark to next desired position, press
key to mark the second point; By analogy, to mark all
desired points.
Note: The number of points must be within 8 to 32.
4. When completed the marking of desired points, press
key, a trace appears on the screen (trace is automatically drawn
along the order of marking points until close the beginning point and end point). The measured circumference and area
values are automatically displayed at the built-in mark “C: ----mm, A: 0.0 mm²” on the right part of the screen; If
continuously marks the thirty-two point, it directly appears trace on the screen, the measured circumference and area
values are automatically displayed at the built-in mark “C: ----mm, A: 0.0 mm²” on the right part of the screen.
5. Press
key again, the cursor will show “+”, repeat steps 3, 4 to complete the multi-group data measurement.
6. Press
key to quit the measurement status.
7. Press direction keys
to choose “Clear” and press
key to clear all marks and data.
8. Press
key to return the real-time status.
7.3 Slope / Heart Rate / Cycle Measurement
In B / M, M frozen status, measure slope / hear rate / cycle. The method is identical with distance measurement.
Note: T denotes cycle measured in ms (millisecond)
HR denotes heart rate measured in times / minute (times per minute)
EF denotes slope coeffi cient measured in mm / s (millimeter per second)
Attention!
The accuracy of software measurement:
• Distance measurement ≤ 0,1 mm
• Area measurement ≤ 0,1 mm²
• Volume measurement ≤ 0,01 cm³
• Heart rate measurement ≤ 1 bpm
• Time measurement ≤ 1 ms.
Due to differences in images obtained by each user in different times, the actual object for the accuracy of the
measurement may be greater than the above-mentioned values.
