13
Setting Up
Power on the Projector
1. Complete peripheral connections (with a
Computer, VCR/DVD, etc.) before turning on the
projector
2. Plug the power cord firmly into the projector and
into a wall socket. The LED indicator flashes
Orange shown in Stand-by mode.
3. Remove the lens cap. If it is closed, it could
become deformed due to the heat produced by
the projection lamp.
4. Press ON/STAND-BY button on the projector or
POWER button on the remote control to start the
projector. The preparation display appears on the
screen and countdown starts.
5. After the countdown, the input source appears
on the screen.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a blank screen. Please change to an input signal
which is compatible with the projector's resolution or set the input signal to a lower setting.
Summary of Contents for EIP-XSP2500
Page 1: ...DLP Projector EIP XSP2500 Owner s Manual ...
Page 41: ...37 Dimension ...