Setting up
1
Selection of network menu
Turn on the projector and display the menu on the screen. Select "Network setting" icon
from the main menu and then press
SELECT
button once. Check that the mode is "On".
If not, change mode to "On" using the point buttons (
7
,
8
).
Network configuration
Confirmation of the network menu
When installing this product to the projector, the network on-screen menu items for this
product are activated automatically. If not activated, the product may not have been
installed correctly. Please check item "Mounting" (
☞
p.7).
Configure the network
Before performing the network configuration, prepare network address numbers (IP
Address, Subnet Mask, Default Gateway, DNS) assigned to the projector. Ask your network
administrator for the network address.
For example, the case where the following network address is set up is explained.
IP Address
: 192.168.1.201
Subnet Mask
: 255.255.255.0
Default Gateway
: 192.168.1.1
DNS
: 0.0.0.0
The default network configuration is set as follows.
IP Address
: 192.168.0.2
Subnet Mask
: 255.255.255.0
Default Gateway
: 0.0.0.0
DNS
: 0.0.0.0
LINK
ACT
✐
The network unit begins restarting each time the mode is set "On".
Network icon
Select "On" or "Off"
with
7
,
8
button
(Example of the screen display)
