7
purposes, avoid tilting it in the cutting plane. The
cutting wheel must have a clean cutting edge.
A diamond cutting wheel is best used to cut hard
stone.
It is prohibited to use the machine on asbestos
materials!
Never use a cutting wheel for rough grinding.
TECHNICAL DATA
Nominal voltage:
230 V ~ 50 Hz
Power consumption:
2350 W
Idle speed:
6.000 rpm
Max. wheel diameter:
230 mm
Drive spindle thread:
M 14
Sound pressure level LPA:
94 dB(A)
Sound power level LWA:
107 dB(A)
Vibration
a
–
w
4,83 m/s
2
Weight
5,1 kg
Totally insulated
II /
쓑
Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
앬
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
앬
We recommend that you clean the device
immediately each time you have finished using it.
앬
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
앬
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
앬
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
앬
Type of machine
앬
Article number of the machine
앬
Identification number of the machine
앬
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
Anl BWS 230-5_SPK1 21.04.2006 9:32 Uhr Seite 7
