Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
The corresponding safety information can be
found in the enclosed booklet.
USE
The belt grinder/sander can be used to sand wood
and to grind iron, plastic and similar materials when
fitted with the correct grinding/sanding belt.
Layout
1 grinding/sanding
plate
2 On/Off
switch
3 locking
button
4 additional
handle
5 dust
bag
6
connection for dust bag
7
clamping lever for grinding/sanding belt
8
grinding/sanding belt adjustment screw
Technical data
Voltage
230 V~ 50 Hz
Power rating
1200 W
Grinding/sanding belt dimensions
100 x 610 mm
Belt speed
480 m/min
Totally insulated
II/
쏾
Sound pressure level LPA
89,4 dB(A)
Sound power level LWA
102,4 dB(A)
Vibration aw
2.53 m/s
2
Weight
6,1 kg
Operating tips
앬
Allow the belt grinder/sander to run up to speed
before you place it against the workpiece.
앬
Do not switch off the belt grinder/sander while
the belt is still touching the workpiece.
앬
Always hold the belt grinder/sander with both
hands during operation.
앬
Always sand wood in the direction of the grain.
Important!
For health reasons it is essential to use the
dust bag!
Fitting the dust bag
Dust is drawn from directly above the grinding/
sanding belt into the dust bag.
Switching On/Off
Switching on:
Press operating switch 2
Continuous duty:
Secure switch 2 in place with
locking button 3
Switching off:
Press briefly on operating
switch 2
앬
The machine can be operated in momentary
action mode or in continuous duty mode.
Changing the grinding/sanding paper
앬
Pull the clamping lever (7) outwards to take the
tension off the grinding/sanding belt.
앬
Pull the used grinding/sanding belt off the drive
rollers.
앬
Slip the new grinding/sanding belt onto the drive
rollers.
앬
Make sure that the running direction of the
grinding/sanding belt (arrows on the inside of the
grinding/sanding belt) are the same as the
running direction of the belt grinder/sander
(arrow on the rear drive roller).
앬
Press back the clamping lever (7) to tension the
grinding/sanding belt.
앬
Switch on the belt grinder/sander. Use the
setting screw (8) to adjust the belt run so that the
grinding/sanding belt runs centrally on both drive
rollers.
6
GB
Anleitung BBS 1200_SPK1 24.08.2006 8:57 Uhr Seite 6
