Dear Customer,
Before you use the cordless polishing machine for
the first time, please read the instructions and
observe the notes on operation and maintenance.
Ensure that these instructions are always kept next
to the unit.
1. Items supplied:
1 Polishing machine 12 V DC
1 Battery charger
1 Charging adapter
2 Polishing hoods
2. Technical data
Battery pack:
NiCd 12 V / 1.7 Ah
Charge voltage for rechargeable battery:
12 V =
Charge current for rechargeable battery:
400 mA
Charge voltage for battery charger:
230 V ~ 50 Hz
Speed:
2800 rpm
Polishing pad:
180 mm dia.
Weight:
2,3 kg
Sound pressure level LPA:
67 dB(A)
Vibration a
w
.
12 m/s
2
Remember:
Wear the necessary, protective clothing when
working with the cordless polishing machine.
Pay attention to the safety regulations.
3. Illustration (fig. 1)
NiCd battery 12V / 1.7 Ah (1)
ON/OFF switch (2)
Polishing disk (3)
4. Proper use
The rechargeable polishing machine is used for pol-
ishing the painted surfaces of motor vehicles. This
appliance is not designed for commercial use.
5. Safety information
Please refer to the booklet included in delivery for the
relevant safety instructions.
5.1 Additional safety instructions
Do not use any abrasive polishing agents!
Use the polishing machine only in a clean and dry
environment.
The polishing machine should be placed on the
polishing surface before being switched on or off.
Do not exert too much pressure when polishing,
but simply allow the polishing machine to glide
over the polishing surface.
Do not polish on hot paint or in the sunshine.
Make sure that you unplug the rechargeable
battery before changing the polishing hood!
the A-weighted equivalent continuous sound
pressure level at the user’s ear lies below
70 dB(A).
Repairs are to be carried out by qualified electrici
ans only.
6. Starting up
6.1 Recharging the rechargeable battery
1. Switch off the machine. Pull out the battery pack
(Figure 1). Simultaneously press the pushlock
button.
2. Check that your mains voltage is the same as that
marked on the data plate of the battery charger.
Plug the battery charger in the plug socket and
connect the charging cable to the charging
adapter. The green LED displayed on the
charging adapter shows that the adapter is ready
to charge.
3. Plug the battery pack into the charging adapter.
The red LED will come on to indicate that the
battery pack is being charged. An empty battery
pack requires a maximum charging period of 7
hours. The charging time for a partially charged
battery is comparatively less. The temperature of
the battery pack may rise slightly during the
charging operation. This is normal.
Important!
The battery charger does not switch off
automatically when the battery is fully
charged.
The red LED extinguishes as soon as
the battery pack is removed from the charging
adapter.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
whether there is good contact at the charging
6
GB
Anleitung AAPM 12 21.12.2004 8:54 Uhr Seite 6
