the compressor will cut in again.
7. In rooms with high relative humidity (over
80%), water droplet are deposited on the surface
of the indoor device in cool mode
Set the horizontal air flap to the vertical air outlet
position and select a HIGH fan speed.
8. Heat mode
In heat mode, the air conditioning system draws in
warm air from the outdoor device and dissipates it
through the indoor device to the indoor area. If the
outdoor temperature falls, the volume of hot air
drawn in through the air conditioning falls
accordingly. At the same time the heat load of the air
conditioning system increases as a result of the large
difference between the indoor and outdoor
temperature. This may result in the air conditioning
system being unable to achieve an adequate room
temperature. Please note that the heat function is
only really suitable for use during autumn and spring.
9. A lightning strike or the mobile phone in a car
in use near the system may cause faults in the
device
In this case disconnect the deviceʼs power supply
briefly and then reconnect it. Press the ON/OFF
button on the remote control to restart the device.
11. Troubleshooting
Device does not start. Check the following:
1.
Is voltage present at the plug socket outlet?
2.
Check the plug fuse!
3.
Is the timer set?
The device does not provide satisfactory cooling!
Check the following:
1.
Has an appropriate temperature been set?
2.
Is the air filter soiled? Clean and fit back in place.
3.
Are the inlets and outlets on the outdoor device
blocked?
4
. Has the sleep mode been set during the day?
5.
Are the connections between the indoor and
outdoor device adequately sealed? There may not
be enough coolant? If so, please contact your
service company.
The remote control does not work!
(Important! It only works within a range of 8 m
from the indoor device.)
1. Are the batteries still OK? Replace if necessary!
2. Have the batteries been inserted correctly?
Check that the + and – terminals are correct!
3. Are there any objects between the indoor unit
and the remote control which may interfere with
the signal? Remove these objects.
In the event of a power failure, check the
following:
Press the ON/OFF key after a power failure.
If the problems remain after checking through the
above points, switch off the device and contact your
service company.
GB
30
Anleitung_SKA_2503_Dual_C_H_SPK7:_ 30.07.2008 12:16 Uhr Seite 30
