6.2 Connecting consumers to the generator
앬
Connect the equipment you want to use to the
230 V~sockets (3)
Important:
These sockets may be loaded
continuously (S1) with 2600W and temporarily (S2)
for a maximum of 5 minutes with 2800W.
앬
The generator is suitable for 230 V~ AC
appliances.
앬
Do not connect the generator to the domestic
power network as this may result in damage to
the generator itself or to other electrical
appliances in your home.
Note: Some electrical appliances (power jigsaws,
drills, etc.) may have a higher level of power
consumption when used in difficult conditions.
6.3 Switching off the engine
앬
Before you switch off the generator, allow it to
run briefly with no consumers so that it can "cool
down”
앬
Move the ON/OFF switch (10) to position "OFF”
with the key.
앬
Close the petrol cock
Important! The generator is fitted with an
overload cut-out.
This shuts down the sockets (3). You can restart the
sockets (3) by pressing the overload cut-out (5).
Important! If this happens, reduce the electric
power you are taking from the generator or
remove any defective connected appliances.
Important! Defective overload cut-outs must be
replaced only by overload cut-outs of identical
design and with the same performance data. If
repairs are necessary, please contact your
customer service center.
7. Cleaning, maintenance, storage and
ordering of spare parts
Switch off the motor and pull the spark plug boot
from the spark plug before doing any cleaning and
maintenance work on the equipment.
Important: Switch off the machine immediately
and contact your service station:
앬
In the event of unusual vibrations or noise
앬
If the engine appears to be overloaded or
misfires
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
7.2 Air filter
In this connection, please also read the service
information.
앬
Clean the air filter at regular intervals, and replace
it if necessary.
앬
Open both clips (Fig. 10/A) and remove the air
filter cover (Fig. 10/B).
앬
Remove the filter elements (Fig. 11/C)
앬
Do not use abrasive cleaning agents or petrol to
clean the elements.
앬
Clean the elements by tapping them on a flat
surface. In cases of stubborn dirt first clean with
soapy water, then rinse with clear water and air-
dry.
앬
Assemble in reverse order
7.3. Spark plug
Check the spark plug for dirt and grime after 20
hours of operation and if necessary clean with a
copper wire brush. Thereafter service the spark plug
after every 50 hours of operation.
앬
Pull off the spark plug boot with a twist.
앬
Remove the spark plug with the supplied spark
plug wrench.
앬
Assemble in reverse order
GB
16
Anleitung_RT_PG_3250_SPK1:_ 02.04.2008 11:29 Uhr Seite 16
