Note:
Use environmentally friendly compressed air
oil if you want to operate the equipment outside the
workshop.
The following lubrication options are available:
7.1 Lubrication by mist oiler
Connect a complete conditioning unit with mist oiler
between the compressed air source and the chisel
hammer. A conditioning unit is available from your
dealer. It is not included in the scope of this delivery.
7.2 Lubrication by hand
Each time before using the compressed air tool
insert 3-5 drops of special compressed air oil into the
compressed air connection. If the compressed air
tool has not been used for several days you must
insert 5-10 drops of special compressed air oil into
the compressed air connection before switching on.
Store your compressed air tool only in a dry room.
7.3 Adjusting the resistance of the reverse facility
(3)
By turning the adjustment screw (5) you can adjust
the resistance when using the reverse facility (3).
The reverse facility is set optimally at the factory and
must not be adjusted before using the equipment for
the first time.
7.4 Other maintenance
No maintenance work needs to be carried out on the
inside of the equipment and at position (A) a shown
in Figure 4.
8. Excluded from the guarantee are:
Wear parts
Damage cause by too much operating pressure.
Damage caused by non-conditioned compressed
air.
Damage caused by improper use or
unauthorized intervention.
9. Cleaning and ordering of spare parts
9.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
We recommend that you clean the equipment
immediately after you use it.
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
9.2 Ordering replacement parts:
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
For our latest prices and information please go to
www.isc-gmbh.info
10. Storage
Store the equipment and accessories out of
childrenʼs reach in a dark and dry place at above
freezing temperature. The ideal storage temperature
is between 5 and 30 °C. Store the equipment in its
original packaging.
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
16
GB
Anleitung_DSS_260_2_SPK7:_ 22.03.2012 10:46 Uhr Seite 16
