Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the enclosed book-let for the safety
instructions.
2. Important information
앬
Only ever use screw gun bits which are suitable
for the purpose and in faultless condition.
앬
Before you begin to screw in walls and masonry,
check for concealed electric wiring, gas pipes
and water pipes.
앬
The screw gun is equipped with a claw coupling.
The spindle does not start to rotate until the
screw is pushed into the workpiece.
앬
Before connecting the equipment to the power
supply make sure that the supply voltage
complies with the specifications on the rating
plate.
3. Layout (Fig. 1)
1. Screwing depth stop
2. Depth setting ring
3. Speed controller
4. Operating switch
5. Locking button
6. Changeover switch
7. Belt holder
8. Chuck
4. Proper use
The screwdriver is designed for the screw-fitting of
plasterboard and particleboard panels in the dry
section sector.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Starting up
5.1 ON/OFF switch (4)
To switch on:
Press the switch (4)
Continuous operation:
Secure the switch (4) with the locking button (5)
To switch off:
Press in the switch (4) briefly
You can select the speed by pressing the switch (4)
to a greater or lesser extent.
You can pre-select the speed by turning the knurled
screw in the switch (4).
5.2 Changeover switch (6)
Using the slide switch above the ON/OFF switch you
can select the direction of rotation of the screwdriver.
5.3 Screwing depth stop (1)
Using the depth setting ring with latching settings you
can pre-select (2) the depth to which the screw is
screwed into the workpiece. The symbols on the
setting ring (2) indicate how the screwing depth is
set.
Clockwise:
bigger screwing depth
Counterclockwise: smaller screwing depth
The best way to determine the re-quired setting is
with a test screw. The screw is held in place by the
magnetic chuck.
Press the tip of the screw firmly against the material
in question until the screwing depth stop (1) comes
up against the workpiece and the coupling
disengages.
5.4 Changing the tool insert
To change the tool insert, rotate the screwing depth
stop (1) with the depth setting ring (2) as far as the
maximum screwing depth and pull off the tool insert
to the front (use pincers if necessary).
5.5 Screwdriving work
It is advisable to use self-centering screws (e.g. Torx,
cross recessed head) as these will enable you to
work safely and reliably. Always make sure that the
tool insert used is of the same size and shape as the
screw.
6
GB
Anleitung TBS_710_SPK7:_ 04.09.2007 11:20 Uhr Seite 6
